Which Type of Polyacrylamide Is Used in Sand Washing Plants?
Sand-washing wastewater contains fine sand, clay and suspended particles that can take a long time to settle naturally. Anionic polyacrylamide (APAM) is commonly evaluated as a flocculant for this type of wastewater. It can help fine particles form larger flocs, supporting faster settling and solid–liquid separation.
The right PAM grade depends on the mineral composition, particle size, water chemistry and treatment equipment. A jar test with the actual slurry is the best way to compare products and determine a suitable dosage.
How Does Anionic PAM Work?
APAM is a water-soluble polymer with long molecular chains. These chains can adsorb onto mineral and clay particles and connect multiple particles through adsorption and polymer bridging, forming larger flocs that settle more readily. Laboratory research on mineral tailings shows that APAM performance can vary with slurry pH, polymer dosage and mineral composition.
This process can help:
- Speed up the settling of fine suspended particles
- Improve the clarity of the supernatant
- Concentrate solids for further dewatering
- Support the reuse of clarified water, when it meets the plant’s process requirements
Results vary by site. APAM does not guarantee a specific settling time, water clarity or cake moisture for every sand-washing operation.
Why Is APAM Commonly Tested for Sand-Washing Wastewater?
Anionic PAM is often considered for mineral-rich wastewater because its polymer chains can promote particle aggregation through bridging. However, the best option may differ between plants. Fine clay content, slurry concentration, pH and dissolved salts can all affect flocculation.
If APAM does not produce strong flocs or clear water, compare other PAM grades or treatment conditions through jar testing instead of increasing the dosage without testing.
How to Prepare and Dose APAM
1. Prepare a dilute solution
Add APAM gradually into clean water while mixing. Avoid pouring the powder in all at once, as this can create gel-like lumps with undissolved powder inside. Use the preparation concentration and hydration time recommended for the specific product.
2. Determine the dosage by testing
Dosage depends on the slurry and treatment system. Start with small, measured additions during jar tests and compare floc size, settling speed, supernatant clarity and sludge handling. Published tailings studies use different dosages and conditions, which is why a single fixed dosage should not be applied to every plant.
3. Mix gently after dosing
After adding the APAM solution, mix enough to distribute it through the slurry. Avoid excessive turbulence that could break the flocs. The appropriate mixing intensity and duration depend on the tank and equipment.
Handling and Storage
Store APAM in a cool, dry place and keep the package sealed to prevent moisture exposure. Avoid creating or inhaling powder dust, and follow the product SDS for protective equipment and handling instructions. Polyacrylamide products may contain residual acrylamide monomer, so product quality and the applicable specification should be checked for the intended application.
Conclusion
Anionic polyacrylamide is a common candidate for treating sand-washing wastewater because it can help fine mineral particles form settleable flocs. For reliable results, select the PAM grade and dosage through tests using the plant’s actual slurry, and follow the product’s preparation and safety instructions.

