Polyacrylamide for Sand Washing Wastewater and Sludge Dewatering

Time:2026-10-13

Treatment Challenges

Sand washing plants need effective solid-liquid separation
to recover process water and manage sludge. Fine silt and
clay particles can make clarification and dewatering difficult.

  • Cloudy clarified water and poor water recovery
  • Wet filter cakes that are difficult to handle
  • High PAM consumption with inconsistent performance

TRONKI evaluates customer samples to identify suitable
polyacrylamide grades and dosing conditions for plant trials.

Our PAM Selection Approach

1. Review the Treatment Process

We review the wastewater source, treatment capacity, current
chemicals, dosing points, and sludge dewatering equipment.
This helps define the testing objectives.

2. Compare Suitable PAM Grades

Different PAM grades are compared using wastewater and sludge
samples. We observe floc formation, settling behavior, and
clarified water quality at different dosages.

3. Check Preparation and Dosing Conditions

Polymer dissolution, solution concentration, mixing, and dosing
location are evaluated alongside product selection. Increasing
dosage alone may not resolve poor treatment performance.

4. Verify Sludge Dewatering Performance

Candidate grades are evaluated for filtration and filter cake
handling. Final selection should be confirmed through an on-site
trial using the customer’s actual equipment.

What We Evaluate

Evaluation Item Testing Focus
Water Clarification Settling behavior and clarified water turbidity
Sludge Dewatering Filtration behavior and filter cake condition
Chemical Consumption Treatment performance across different PAM dosages

Performance depends on wastewater characteristics and operating
conditions. Wet filter cakes may also require checks of filter
cloths, feed pressure, and the filtration cycle.

Information Needed for Testing

  • Wastewater and sludge samples
  • Current PAM grade and dosage
  • Treatment capacity and sludge solids content, if available
  • Dewatering equipment type and operating conditions
  • Photos of clarified water and filter cakes
  • Your main treatment targets

Frequently Asked Questions

Can one PAM grade handle both clarification and dewatering?

Sometimes, but the requirements can differ. Both stages should
be tested before selecting a grade.

Does a higher dosage always improve performance?

No. The suitable dosage depends on the sample and process.
Testing helps identify effective dosing conditions and avoid
unnecessary consumption.

Can laboratory testing determine the final operating dosage?

Laboratory testing provides a starting point. The grade and
dosage should then be verified under actual plant conditions.

Request a PAM Selection Test

Experiencing cloudy water, wet filter cakes, or high PAM
consumption? Share your treatment process and sample
information with TRONKI to discuss suitable testing options.


Contact TRONKI

 

 

 

 

 

News Recommended